DIY WiFi Robotic Car Kit: L293 Motor Driver and ESP8266 Arduino Compatible

DIY WiFi Robotic Car Kit: L293 Motor Driver and ESP8266 Arduino Compatible
DIY WiFi Robotic Car Kit: L293 Motor Driver and ESP8266 Arduino Compatible DIY WiFi Robotic Car Kit: L293 Motor Driver and ESP8266 Arduino Compatible DIY WiFi Robotic Car Kit: L293 Motor Driver and ESP8266 Arduino Compatible
Product Code: MYD0263
Availability: Out of stock
Price: RM95.40
Exclude GST: RM90.00
Notify Me

This is a Q68NodeMcu Lua ESP8266 WiFi IoT DIY Robotic Car Kit base on ESP-12E WiFi Development Board, with L293D WiFi Motor Drive Board selectable.

ESP8266 ESP-12E NodeMcu Lua WiFi Development Board:

FEATURES

  • NodeMcu Lua ESP-12E WIFI Development Board
  • Wireless 802.11 b/g/n standard
  • Support STA / AP / STA + AP three operating modes
  • Built-in TCP / IP protocol stack to support multiple TCP Client connections (5 MAX)
  • D0 ~ D8, SD1 ~ SD3: used as GPIO, PWM, IIC, etc., port driver capability 15mA
  • AD0: 1 channel ADC
  • Input: 4.5V ~ 9V (10VMAX), USB-powered
  • Current: continuous transmission: ≈70mA (200mA MAX), Standby: <200uA
  • Transfer rate:110-460800bps
  • Support UART / GPIO data communication interface
  • Remote firmware upgrade (OTA)
  • Support Smart Link Smart Networking
  • Working temperature: -40 ℃ ~ + 125 ℃
  • Drive Type: Dual high-power H-bridge driver

 
L293D WiFi Motor Drive Expansion Board Shield:

NodeMcu Lua WiFi Development Board base on ESP-12E, a low cost wifi development board for you to DIY with NodeMCU platform. Chip:CP2102; CP210x USB to UART Bridge VCP Drivers: http://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx

Official Website: http://www.nodemcu.com/index_en.html

FEATURES

  • NodeMcu Lua ESP-12E WIFI Development Board
  • Wireless 802.11 b/g/n standard
  • Support STA / AP / STA + AP three operating modes
  • Built-in TCP / IP protocol stack to support multiple TCP Client connections (5 MAX)
  • D0 ~ D8, SD1 ~ SD3: used as GPIO, PWM, IIC, etc., port driver capability 15mA
  • AD0: 1 channel ADC
  • Input: 4.5V ~ 9V (10VMAX), USB-powered
  • Current: continuous transmission: ≈70mA (200mA MAX), Standby: <200uA
  • Transfer rate:110-460800bps
  • Support UART / GPIO data communication interface
  • Remote firmware upgrade (OTA)
  • Support Smart Link Smart Networking
  • Working temperature: -40 ℃ ~ + 125 ℃
  • Drive Type: Dual high-power H-bridge driver

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Notify Me When This Product is Available