L293D Motor Drive Shield for Arduino

L293D Motor Drive Shield for Arduino
L293D Motor Drive Shield for Arduino
Product Code: MYD1569
Availability: 9
Price: RM22.00
Exclude GST: RM22.00
Qty:     - OR -   Add to Wish List
Add to Compare

L293D is a monolithic integrated, high voltage, high current, 4-channel driver. Basically this means using this chip you can use DC motors and power supplies of up to 36 Volts, that's some pretty big motors and the chip can supply a maximum current of 600mA per channel. The L293D chip is also known as a type of H-Bridge. The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.g. motor.


  • 2 interface for 5V Servo connected to For Aduino's high-resolution dedicated timer - no jitter!
  • Can drive 4 DC motors or 2 stepper motors or 2 Servo
  • Up to 4 bi-directional DC motors with individual 8-bit speed selection
  • Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.
  • 4 H-Bridges: per bridge provides 0.6A (1.2A peak current) with thermal protection, can run motors on 4.5V to 16V DC
  • Pull down resistors keep motors disabled during power-up - reset button - 2 external terminal power interface, for seperate logic/motor supplies
  • Tested compatible for Aduino Mega, Diecimila & Duemilanove


  • 1xL293D Motor Drive Shield for Arduino

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:

Notify Me When This Product is Available