WiFi Shield V2.1 For Arduino (802.11 b/g/n)

Introduction
DFRobot is very proud to release this first 802 b/g/n wifi shield in the Arduino market. The shield uses WizFi210which  is a low power-consuming WIFI module which is applied with dynamic power management technology.  When the WIFI module needs to be on but not work, it can be set to Standby mode a low power mode, and the module just needs to be woken up when it has to work.
The WIFI wireless module is based on WizFi210. It provides the bridging from TTL serial port communication to IEEE802.11b/g/n wireless communication. So any device with TTL serial ports can easily be connected with this WIFI module and controlled and managed remotely through a wireless network. Different kinds of communication protocols and encryption algorithms are integrated with the module. The Arduino architecture enables you to easily integrate this module into any Arduino based project.
 
 
 
Features

    Bring WiFi connectivity via Serial Host Interface, compatiable with Arduino
    Quick Booting Time : under 20msec
    Ultra Low Power through Dynamic Power Management (34µA at the Standby mode)
    Operates with standard 802.11b/g/n access point at speed up to 11Mbps (802.11b)
    Security Protocol : WEP, WPA/WPA2-PSK, Enterprise, EAP-FAST, EAP-TLS, EAP-TTLS, PEAP
    Operation Temperature : -40℃ ~ 85℃
    Compact Size : 32 x 23.5 x 2.9 (mm)
    CE, FCC, KCC Certified
    Supports the module with chip antenna
    802.11b/g/n

Specifications

    Wifi Chip: WizFi210
    Radio Protocol: IEEE 802.11b/g/n Compatible
    Supported Data Rates: 11, 5.5, 2, 1 Mbps (IEEE 802.11b)
    Modulation: DSSS and CCK
    RF Operating Frequency: 2.4 - 2.497 GHz
    Antenna Options: Chip antenna and U.FL connector for external antenna
    Networking Protocols: UDP, TCP/IP (IPv4), DHCP, ARP, DNS, HTTP/HTTPS Client and Server(*)
    Power Consumption(Typical): Standby = 34.0 µA Receive = 125.0 mA Transmit = 135.0 mA
    RF Output Power (Typical): 8dBm ± 1dBm
    Security Protocols: WEP, WPA/WPA2–PSK, Enterprise, EAP-FAST, EAP-TLS, EAP-TTLS, PEAP
    I/O Interface: UART, SPI(*), I2C(*), WAKE, ALARM, GPIOs
    Power Source: 3.3V
    Dimensions(except Antenna): 59 x 54 mm

 
Shipping List

    WiFi Shield V2.1 for Arduino (1 unit)
    Antenna (1 unit)

Documents

    WiFi Shield Schematic
    WizFi210 datasheet
    Tutorial
    AT Command Tutorial
    WizSmart Software
    WiFi Infrastructure(Limited AP, WiFi Station)
    How to set up AP in WizFi210